![]() ![]() If I connect to a wifi (with 7260) in the host with kali and alfa running the alfa stops working in Kali. Now however the problem is that when I plug in the Alfa device my network connection from my other wifi ceases to work (Intel(R) Wireless-N 7260) (the connection bridged from my host). So now when i run ifconfig I get that wlan0 is up (Alfa) but eth0 is down (Intel(R) Wireless-N 7260). The trick was to add a new custom USB device in virtualbox where you just take the vendor ID and product ID from the alfa device and leave the other boxes blank. Which helped me getting the Alfa card to work in Kali. You should now that I'm not too good with Linux etc. I really don't know what I should do here. I thought that maybe it didn't have the right drivers so i tried to apt-get install firmware-atheros but it said that it was already installed. ![]() Ifconfig shows my bridged connection and Local loopback.īus 001. Note that if your run your VM on all cores available you may. Enable hardware virtualization (VT-x/AMD-V) in the Acceleration tab. Iwconfig in Kali gives no wireless extensions. To enable more than 1 CPU in your VM the following settings are needed in addition: 64-bit virtual guest hardware in General settings tab (for 64-bit guests) Enable I/O APIC in the Motherboard settings tab. I have bridged my hosts network connection (Intel(R) Wireless-N 7260) with Kali and I have set up the Alfa 036nha as a usb device for Kali through virtualbox. I've also installed the VirtualBox 4.3.12 Oracle VM VirtualBox Extension Pack. I'm running Kali Linux 64bit 1.07 as a guest os through virtualbox 4.3.12 r93733. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |